Avtec Dental America's Handpiece Specialists

DynaTorq Wrench & Complete Driver Kit

$495.00
SKU:
ITLTWK
Qty:

DynaTorq Wrench & Complete Driver Kit

The DynaTorqWrench & Driver Kit
(Select preferred torque above right)

 

This kit has you covered for restoring to all major implant systems.


The Kit Includes:
1 - 
ITLTW - DynaTorq Wrench 35 Ncm
1 - ITLTW - DynaTorq Wrench 20 Ncm
1 - 
HNT- .048 Hex Driver Tapered 
1 - 
HNLT - .048 Hex Driver Long Tapered
1 - 
HTT - .050 Hex Driver Tapered
1 - 
HTLT - .050 Hex Driver Long Tapered
1 - 
PROCS - Torx Driver For NobelBiocare
1 - 
PROCL - Torx Driver Long - For NobelBiocare
1 - 
ITIS - Torx Driver - For ITI
1 - 
ITIL - Torx Driver Long - For ITI
1 - 
TK - Manual Thumb Knob

 

 

  • AFFORDABLE.
  • EASY TO USE.
  • ACHIEVES CONSISTENT PRE-LOADING OF IMPLANT ABUTMENTS AND SCREWS.
  • EASY MAINTENANCE - STAINLESS STEEL - STERILIZE BY AUTOCLAVE OR CHEMCLAVE.

Tightening with the correct torque minimizes the risk of the screw working loose and improves the precision during bridge fabrication. Torque control can also reduce the risk of stress being built into the restoration and prevent component fractures.
 

The DynaTorq® Wrench is a pre-calibrated torque wrench system that prevents over and under tightening of implant screws and abutments. It is available in 10Ncm, 20Ncm, 30Ncm, 32Ncm and 35Ncm settings to meet the needs of a variety of implant systems. An assortment of drivers fit all the hex or slot head screws regardless of implant type.

 

Insert the screw or abutment into the implant with the  driver and tighten with finger pressure. Remove the driver and place into the DynaTorq® Wrench. Pre-load the screw by using the wrench in the same way as a ratchet wrench. The wrench clutch will disengage when the pre-calibrated torque is applied.

 

 

Drivers fit all hex or slot head screws regardless of implant type

 

Shaft releases from head discontinuing torque drive at optimal pre-load